Beer & Air Line
Beer Line Jumper 5' w/connectors
5 feet of clear 3/16" beer line. Includes nipples, hex nuts, clamps and rubber washers. Connects from the back of the shank to the keg coupler. Comes completely assembled.
Air Line Jumper 5' w/screw clamps
5 feet of 5/16" air line. One side clamps to the air nipple on your keg coupler and the other connects to the shut-off valve on your regulator. Clamp it tight using the included screw clamps.
Beer Line by the Foot
Assemble your own beer line. 3/16" inside diameter clear vinyl line. Food Grade. Use this for runs of 8' or less. Connecting hardware not included.
Connectors for Beer Lines
There are four pieces that are needed on each end of your beer line to properly connect it to your beer system. Set includes the proper components to fit your 3/16" ID tubing to shank and/or keg coupler.
Tower Beer Line Jumper
This beer line is for single tap towers. Has the connection on one end to the keg coupler. The other end attaches inside your tower.
Air Line by the Foot
If you need more than 5' of airline you can grab it here by the foot. Inside diameter is 5/16". Food Grade. Connecting Hardware not included.
Screw Clamp
Screw these clamps with a flat head screw drive to secure hosing around the inserted component. Works with all tubing sizes up to 9/16".
Beer line w/ Plastic Faucet Head w/ Hex Nut Assembly
Two feet of beer line w/ plastic faucet head. Connect this to your coupler/keg to dispense beer directly from the included plastic faucet. Perfect for dispensing from kegs at parties.
Beer Line Rubber Washer Set of 6
These are the rubber washers that go inside the hex nut of a beer line jumper. Set of six.
Beer Line Hose Joining Kit
This is used to connect two existing 3/16" inside diameter beer lines together. Diameter inside hose union splice remains the same.